PYTHA - Type Automatic for Vertically Stacked Cabinets

PYTHA - Type Automatic for Vertically Stacked Cabinets

When running type automatic on two cabinets, vertically stacked that share one door, changes must be made to ensure the correct amount of hinges are applied to the door and cabinets.
If not, hinges will only be applied to one of the cabinets. This is easily amended by changing the Part name of one end panel and adding the relationships to the machining definitions.

Please follow the instructions in the below video,
  1. Change the Part name of the top cabinet end, from End_LH to End_LH1
  2. Go to PYTHA WORKSHOP>Define
  3. Open the relationship between Door_LH,End_LH
  4. Go Edit>New
  5. Enter new name, Door_LH,End_LH1
  6. Click Pattern File>Save
  7. Do these steps again to create relationships between the following
    1. End_LH1,Back
    2. End_LH1,Bottom
    3. End_LH1,Adj_Shelf
    4. End_LH1,CR_Front
    5. End_LH1,CR_Back            







    • Related Articles

    • PYTHA Workshop - Type Automatic Name Filters

      Type Automatic includes Part Name filters that ensure correct machining is applied depending on your pattern setup and part naming. It is highly recommended that both these filters be activated when running Type Automatic to ensure only the required ...

    • PYTHA Workshop - Manually Move Or Delete Type Automatic Bore Holes

      Occasionally it may be necessary to MANUALLY reposition or remove one or more of the bore holes generated by Type Automatic. You may need to MOVE a hinge so that it doesn't foul on an inner drawer or DELETE a single construction hole to ensure it ...

    • PYTHA Workshop - Removing Ghost Points

      Occasionally moving parts that have Type Automatic bore holes can create additional points, such as those shown in the image below. These points lose their connection to the original bore holes and can't be deleted using the usual Workshop > Bore ...

    • PYTHA Workshop - Creating Rebates With Router Edges

      In PYTHA Workshop, the Router Edges function allows for the creation and export of custom routing. This could be machining for a recessed handle, a groove for an LED light strip housing, or any other face routing that cannot be generated through Type ...

    • PYTHA - Blind and Corner Cabinets Drill Holes Discrepancy

      We've identified that there is an issue when using the Drill Holes function after rotating Blind and Corner Cabinets. The boreholes relating to the hinge are set to the face of the cabinetry (see the below image). This an ongoing issue that has been ...