PYTHA Workshop - Manually Move Or Delete Type Automatic Bore Holes

PYTHA Workshop - Manually Move Or Delete Type Automatic Bore Holes

Occasionally it may be necessary to MANUALLY reposition or remove one or more of the bore holes generated by Type Automatic. You may need to MOVE a hinge so that it doesn't foul on an inner drawer or DELETE a single construction hole to ensure it does not interfere with certain hardware. 

This can be done using FACE TOOLS after you have run Type Automatic. 

           

To MOVE bore holes:     
  1. Select Face Tools > Edit > Move
           
  1. Select the bore holes that you would like to reposition
  2. Use the Gizmo or input bar to move the bore holes by the required amount

To DELETE bore holes:
  1. Select Face Tools > Edit > Delete
           
  1. Select the bore holes that you would like to remove
  2. Centre click to confirm and delete the selected bore holes


    • Related Articles

    • PYTHA Workshop - Removing Ghost Points

      Occasionally moving parts that have Type Automatic bore holes can create additional points, such as those shown in the image below. These points lose their connection to the original bore holes and can't be deleted using the usual Workshop > Bore ...

    • PYTHA Workshop - Type Automatic Name Filters

      Type Automatic includes Part Name filters that ensure correct machining is applied depending on your pattern setup and part naming. It is highly recommended that both these filters be activated when running Type Automatic to ensure only the required ...

    • PYTHA - Type Automatic for Vertically Stacked Cabinets

      When running type automatic on two cabinets, vertically stacked that share one door, changes must be made to ensure the correct amount of hinges are applied to the door and cabinets. If not, hinges will only be applied to one of the cabinets. This is ...

    • PYTHA Workshop - My Holes (PYTHA 25 and above)

      In PYTHA Workshop, the My Holes function allows for the creation and export of custom drilling. To create Vertical or Horizontal bore holes: Draw a Circular face on the surface or edge of the part you wish to drill - the diameter of the face ...

    • PYTHA Workshop - Controlling Segments For My Holes

      When drawing circular faces to turn into My Holes, it is best not to use a large number of segments. Large numbers of segments are not needed to define drilling and will inflate file size unnecessarily. It is best to use an even number of segments ...